Home
Branding Irons
Branded Gifts
Samples & Info
Ordering Info
Contact
Compliments
Resources

 

 

 

 

 

 

Western Brands

How to Read Western Branding Irons:  Western branding irons read from left to right, from top to bottom and outside to inside.

A letter laid on its side, either left or right, is read as "lazy".  
An upside down letter is read as "crazy". 
A backwards letter is read as "reverse".  
A dash or line before, after, between, over or under the letters is read as a "bar".
"Combined" is when 2 letters share a common side or upright.
"Connected" are when 2 letters connect in some manner.
"Offset" is when one letter is slightly lower and to the side of the other.
"Hanging" is when a letter is connected to the bottom of another.
A back slash ( \ ) is called a "rail".
A forward slash ( / ) is called a "slash".
1/4 of a circle above letters is called a "quarter circle".
1/4 of a circle below letters is called "rocking".

How to Order Western Branding Irons:  You may use a combination of the Western styles listed, however, don't choose randomly.  Make a sketch on paper before you submit your chosen Western style branding iron design.  Be sure to specify terms such as "over", "under", "before", "after", "between" & "offset".  These terms will help determine placement of symbols and letters.  If you have a specific design in mind, please send a drawing via email or fax.  Brands can be read differently so if no drawing is submitted your design will be left up to our interpretation.

Here's some samples . . .

 

.

2 Letter Western Brand

Bar over

N combined B

Solution Graphics

Tel:                             Fax:                         eMail:
(USA) 480.330.3619                     (USA) 480.596.5746                info@tbonebrands.com

© 2005, 2006, 2007, 2008 T-Bone Brands - All logos, content and photographs are copyrighted by T-Bone Brands.  The T-Bone logo is a registered trademark.  Their use is protected under Federal Copyright Laws.